What is a Wood Processor Throttle Governor?
A wood processor throttle governor is a device used to regulate the speed of a wood processing machine. It is designed to sense the load on the machine and automatically adjust the speed to maintain consistent output. The governor is typically a mechanical device that uses a flywheel, springs, and weights to sense and adjust the engine speed. It is also possible to use an electronic device to serve the same purpose. The throttle governor is an important safety feature on wood processors, as it helps to prevent accidents caused by excessive speeds.A throttle governor is an electronic control system that makes the engine run at a constant speed. The system uses a PI controller implemented on an ATMEGA 168 microprocessor to adjust the throttle position based on the engine’s speed. The wood processor’s original throttle was set to a single position and controlled by a servo motor. Using the governor, the engine’s power can be increased to cope with heavy loading.
Log capacity
A wood processor’s log capacity can be determined by a variety of factors. The size of the log is an important consideration. Large logs, such as those used to heat large outdoor wood boilers, require a larger machine than small pieces, which are typically used for campfires and firewood. However, the size of the machine you purchase can also be influenced by the species of logs you process.
The 16-24 firewood processor is the largest firewood processor on the market, yet it’s also the most affordable. It comes standard with a 38 HP Kohler EFI big-block gas engine and can process logs from 18 inches to 24 inches in diameter. It also has hydraulic lever-type controls to operate the saw and clamp.
Log size
To control the speed of a wood processor, you need to know the log size and the throttle governor. The size of the throttle determines the power output and fuel consumption. It should be low enough to avoid engine damage while idle, but high enough to prevent stalling during heavy loading. The wood processor throttle is usually set to one position, but it may need to be adjusted in certain ways to optimize its efficiency.
You can choose a firewood processor to process logs up to 18 inches in diameter. Some models also have delimbing mechanisms that split the logs into smaller pieces. The wood produced with a firewood processor can be used for home heating, or sold to customers. You should know the size of your log before purchasing a wood processor to ensure the right size for your home’s heating needs.
Log speed
In order to properly run a wood processor, the throttle must be set correctly. It should be adjusted low to avoid damaging the engine at idle, and high to avoid stalling during peak loading. Each manufacturer provides a list of operating parameters for their wood processors. Using a video to demonstrate the wood processor’s features will help you choose the best wood processor for your needs.
The design of your firewood processor will vary depending on the market you’re targeting and the species of logs you have to process. You may want to produce large pieces of firewood for people who use outdoor wood boilers, while restaurants may prefer smaller pieces for cooking. Depending on the size of your firewood, you may need a larger machine.
